Step 2: Clean arrow with adhesive removal (Goof, GooGone, etc)
Step 3: Wipe arrow off with alcohol (rubbing, not whiskey)...
DO NOT wipe the wrap off with anything
Step 4: Lay wrap, adhesive side up on a solid surface (mouse pad works great)
Step 5: Line up the end of the arrow (nock removed) with the end of the wrap and slide until the arrow meets the wrap (parallel)
Step 6: Press down and roll the arrow slowly and with some pressure into the wrap
Step 7: Fletch
Fletching Glue Recommendation
We use Bohning Fletch Tite and Bohning Fletch Tite Platinum with both feathers and blazer vanes. We recommend that you leave each feather/vane on the jig with the clamp in place for 15-20 minutes before moving on to the next. After fletching your arrow, put a drop of glue at the top and bottom of the fletching.
Do not smoke around your fletching area...it will dry out adhesives.
Arrow Wrap Removal
Step 1: Heat the wrap (about an inch at a time) with a hairdryer or over boiling water (steam) for a couple of minutes
